Yokogawa YFGW710 - Manual (Page 74)

B1-10
IM 01W01F01-01EN
n Gateway Field
Table B1-4 Setting Gateway
Parameter name Setting value Remark
Device Tag Specify the device tag of the gateway. By default, the device tag is YFGW-
GWnnn.
nnn is from 001 to 999, any of which is
automatically assigned so that the device
tag is unique in the project.
n System Manager/Security Manager Field
Table B1-5 Setting System Manager/Security Manager
Parameter name Setting value Remark
Device Tag Specify the device tag of System Manager. By default, the device tag is YFGW-
SMnnn.
nnn is from 001 to 999, any of which is
automatically assigned so that the device
tag is unique in the project.
EUI-64 EUI-64 of System Manager Display only
Channels Check the channels to use. By default, all 15
channels are checked.
Clear the check mark for channels that are
prohibited by the radio law of the country or
region where YFGW710 is used.
Channels 0 to 14 are displayed in Field
Wireless Configurator. These channels
correspond to channels 11 to 25 defined in
IEEE 802.15.4.
Topology Specify the network topology.
The following two types can be selected.
• Star (default)
• Mesh
For details on changing the network topol-
ogy, refer to section B1.2.2.5.
Max Nodes 50 nodes is specified by default. Do not change it.
Max Latency 0% is specified by default. Do not change it.
Max Device Timeout 120 seconds is specified by default. Do not change it.
Advertise Period 7 seconds is specified by default. Do not change it.
Join Links Period 4 seconds is specified by default. Do not change it.
PER 15% is specified by default. When the network is a mesh topology, this
is the standard for switching paths.
TIP
There is the case that notation of “EUI64” is used for device unique 64bits address (EUI-64) of both the field wire-
less devices and each function of YFGW710 in display of software that is referenced “PART C C2. Field Wireless
Configurator” by this chapter.