Caution, Ncautions for safely applying the device – Yokogawa YFGW710 User Manual

Page 11

iii

IM 01W01F01-01EN

Cautions for Safely Applying the Device:

EMC Conformity Standards

EN61326-1 Class A, Table 2 (For use in industrial locations), EN61000-6-2

CAUTION

This instrument is a Class A product, and it is designed for use in the industrial environment.
Please use this instrument in the industrial environment only.

Low Voltage Directive

Applicable standard: EN61010-1
(1) Pollution Degree 2
“Pollution degree” describes the degree to which a solid, liquid, or gas which deteriorates dielec-

tric strength or surface resistivity is adhering. “2” applies to normal indoor atmosphere. Normally,

only non-conductive pollution occurs. Occasionally, however, temporary conductivity caused by

condensation must be expected.
(2) Installation Category I
“Overvoltage category (Installation category)” describes a number which defines a transient over-

voltage condition. It implies the regulation for impulse withstand voltage.
“I” applies to electrical equipment which is supplied from the circuit when appropriate transient

overvoltage control means (interface) are provided.

Regulatory Compliance for Radio and Telecommunication

Please confirm that a installation region fulfils a standards, require additional regulatory informa-

tion and approvals, contact to Yokogawa Electric Corporation.
• Radio and Telecommunications
Terminal Equipment Directive (R&TTE)
We, Yokogawa Electric Corporation hereby declare that this equipment, YFGW710 is in compli-

ance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
The CE declaration of conformity for R&TTE for this product can be found at http://www.

yokogawa.com/fld/