Interfaces (v35), Interfaces (fxs), Interfaces (v35) interfaces (fxs) – ADTRAN 600R User Manual
Page 84: V35), Fxs)

Section 4 User Interface Guide
Total Access 600 Series System Manual
82
© 2004 ADTRAN, Inc.
61200624L1-1B
I
NTERFACES
(V35)
View the V.35 interface status and configure the V.35 parameters from this menu.
I
NTERFACES
(V35) > C
ONFIG
Configure the DTE leads from this menu.
I
NTERFACES
(V35) > C
ONFIG
> CTS
Sets the control characteristic of the clear-to-send lead. Choices are
N
ORMAL
(follows RTS) or
F
ORCE
ON
.
Default is
N
ORMAL
.
I
NTERFACES
(V35) > C
ONFIG
> DCD
Sets the control characteristic of the carrier detect lead. Choices are
N
ORMAL
(follows valid signal on the
network interface) or
F
ORCE
ON
.
Default is
N
ORMAL
.
I
NTERFACES
(V35) > C
ONFIG
> DSR
Sets the control characteristic of the data set ready lead. Choices are
N
ORMAL
(follows DTR) or
F
ORCE
ON
.
Default is
N
ORMAL
.
I
NTERFACES
(V35) > S
TATUS
View the status of the DTE leads from this menu.
I
NTERFACES
(V35) > S
TATUS
> RTS
View the status of Request to Send (RTS) lead. Possibilities are
O
FF
or
O
N
.
I
NTERFACES
(V35) > S
TATUS
> DTR
View the status of the Data Terminal Read (DTR) lead. Possibilities are
O
FF
and
O
N
.
I
NTERFACES
(V35) > T
EST
These options are used to loopback tests.
I
NTERFACES
(V35) > T
EST
> L
OOPBACK
Enables a local loopback of the V.35 interface. All data received on the V.35 interface is transmitted back out
the interface.
I
NTERFACES
(FXS)
View the FXS interface status and configure the FXS parameters from this menu.
I
NTERFACES
(FXS) > C
ONFIG
Configure the FXS mode, line impedance and Tandem parameters from this menu.