ADTRAN 600R User Manual
Page 61
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
59
SYSLOG using Terminal Mode
Another option for configuring syslog is using the terminal mode command log dump
logname must be all CAPS must match the listings below. The command will dump all messages for the
indicated log (
ALL L
EVEL
shows all log messages) stored in the internal log buffer to the command line
display.
S
YSTEM
C
ONFIG
> S
YSLOG
> ALL L
EVEL
This entry allows setting the default reporting level for all log entries. If
ALL L
EVEL
is a lower priority than
the individual log entry level,
ALL L
EVEL
overrides the individual log reporting level.
S
YSTEM
C
ONFIG
> S
YSLOG
> KERNEL L
EVEL
Minimum required level for sending KERNEL log messages. Kernel messages provide low-level status
information concerning the operation of the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> DHCP L
EVEL
Minimum required level for sending DHCP log messages. DHCP log messages provide status information
on IP addressing information concerning the DHCP server or clients.
S
YSTEM
C
ONFIG
> S
YSLOG
> NTP L
EVEL
Minimum required level for sending NTP log messages. Network Time Protocol log messages provide
information regarding the network time settings.
S
YSTEM
C
ONFIG
> S
YSLOG
> TFTP L
EVEL
Minimum required level for sending TFTP log messages. TFTP log messages provide status information
concerning firmware upgrades and configuration transfers utilizing the TFTP protocol.
S
YSTEM
C
ONFIG
> S
YSLOG
> TELNET L
EVEL
Minimum required level for sending TELNET log messages.Telnet log messages provide status
information concerning telnet requests and connections to the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> IP L
EVEL
Minimum required level for sending IP log messages. IP log messages provide information concerning IP
packets that are sent and received to and from the unit.
S
YSTEM
C
ONFIG
> S
YSLOG
> PPP L
EVEL
Minimum required level for sending PPP log messages. PPP log messages provide status information
concerning PPP packets and connections through the system.
S
YSTEM
C
ONFIG
> S
YSLOG
> NAT L
EVEL
Minimum required level for sending NAT log messages. NAT log messages provide status information
concerning Network Address Translation being performed by the system.