System config, Figure 4, System config menu – ADTRAN 600R User Manual
Page 53
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
51
S
YSTEM
C
ONFIG
Set up the unit’s operational configuration from the
S
YSTEM
C
ONFIG
menu. Figure 4 shows the items
included in this menu.
Figure 4. System Config Menu
S
YSTEM
C
ONFIG
> M
ANAGEMENT
Set up the
CRAFT
port,
T
ELNET
A
CCESS
,
SNMP M
ANAGEMENT
, and
FDL M
ANAGEMENT
from this menu.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> CRAFT P
ORT
Set up the
CRAFT
port parameters from this menu. The unit’s VT100
CRAFT
port can be accessed via an
RJ-48 connector located on the rear of the unit.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> CRAFT P
ORT
> P
ASSWORD
P
ROTECT
When
P
ASSWORD
P
ROTECT
is set to
N
O
, the
CRAFT
port is not password protected. When set to
Y
ES
(def),
the unit will prompt for a password upon startup.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> CRAFT P
ORT
> P
ASSWORD
Enter the user-defined password (up to 30 alphanumeric characters including spaces and special
characters) to protect the
CRAFT
port. By default, no password is entered. Table 2 on page 52 provides
instructions for changing the password.
Connecting directly to the
CRAFT
port provides full access to all menus. Enable the
password on the
CRAFT
port to protect against unauthorized access.