ADTRAN 600R User Manual
Page 57
Total Access 600 Series System Manual
Section 4 User Interface Guide
61200624L1-1B
© 2004 ADTRAN, Inc.
55
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> T
ELNET
A
CCESS
> IP A
CCESS
L
IST
Set up the list of allowed Telnet connections by specifying the IP address of the systems used to control the
unit.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> SNMP M
ANAGEMENT
Activate the SNMP management and configure the SNMP communities and traps from this menu.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> SNMP M
ANAGEMENT
> A
CCESS
When set to
O
FF
, SNMP access is denied. When set to
O
N
, the unit will respond to SNMP managers based
on the configuration of the
C
OMMUNITIES
fields. The factory default is
O
N
.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> SNMP M
ANAGEMENT
> T
RAP
D
ELAY
When enabled, the Total Access 600 Series inserts a delay before transmitting a created trap for the SNMP
session.
S
YSTEM
C
ONFIG
> M
ANAGEMENT
> SNMP M
ANAGEMENT
> C
OMMUNITIES
Set up the SNMP communities parameters from this menu.
N
ETWORK
A
DDRESS
Enter network addresses from which Telnet access to the unit is allowed. When a remote unit
requests Telnet access to the unit, if the access list is empty or the remote’s IP address matches a list
entry, remote access is granted. A network address of 0.0.0.0 with corresponding netmask
255.255.255.255 blocks all host Telnet access.
The factory default is
0.0.0.0.
(with a
0.0.0.0
subnet
M
ASK
), which allows all users Telnet access.
M
ASK
The mask is used to determine which bits of the
N
ETWORK
A
DDRESS
are significant. A "0" bit means
"don't care." A "1" bit means that the corresponding address bits in the incoming IP packet must
match the address bit in the defined
N
ETWORK
A
DDRESS
. The netmask of 255.255.255.255 defines a
single IP as the only allowed IP address from the specified network. A
N
ETWORK
A
DDRESS
defined as
192.22.1.0 with a
N
ETMASK
of 255.255.255.0 allows all units on the 192.22.1.0 network Telnet
access to the unit. The default value is
0.0.0.0
(with a default
N
ETWORK
A
DDRESS
of
0.0.0.0
), which
allows all users Telnet access.
#
Displays the index number of the SNMP Communities. This list is used to set up to 8 SNMP
communities that the unit will allow.
N
AME
This is the text string used to identify the SNMP community. The factory default is no entry in the
name parameter.