ADTRAN 600R - Manual (Page 107)

Total Access 600 Series System Manual Section 4 User Interface Guide
61200624L1-1B © 2004 ADTRAN, Inc. 105
L2 P
ROTOCOL
(ATM–NET–ATM) > C
ONFIG
> PVC C
ONFIG
> S
ETUP
(V35)
Use these menus to configure the V35 parameters for this logical connection from the T1 interface to the
V.35 port. These menus are only applicable when the
C ONNECTION
parameter is set to V35 .
M AX C ONFIG
This value is the number of unanswered configuration-requests that should be
transmitted before resetting PPP negotiations. the possible values are
5 , 10 , 15 ,
and 20 (def).
M AX T IMER ( SEC )
This value is the number of seconds to wait between unanswered
configuration-requests. The possible values are
1 SEC
, 2 SECS
, 3 SECS ( DEF ) ,
5 SECS
, and 10 SECS
.
M AX F AILURE
Due to the nature of PPP, configuration option may not be agreed upon between
two PPP peers. This value is the number of configuration-naks that should occur
before an option is configuration-rejected. The possible values are
5 ( DEF ) , 10 ,
15 , and 20 .
F ORCE P EER IP A DDRESS
This option forces the PPP to negotiate the IP address entered instead of
allowing another address to be assigned by the remote end. The default is
N O
.
K EEPALIVE P ERIOD
This option allows the user to generate PPP keepalive packets that can be sent
every
1 minute, 2 minutes, or every 5 minutes. A value of 0 (O FF ) disables the
PPP keepalive packet generating feature. The default is 0 (O FF ) .
PPP E NCAPSULATION
This option allows the user to set the encapsulation modes for PPP over ATM.
LLC has an encapsulation header in the AAL5 frame indicating it is
encapsulating PPP. VC-Mux does not have a header, and is therefor dedicated to
using PPP. The choices are
LLC or VC-M UX
. The default is VC-M UX
.
S END I DENTIFICATION
When enabled, this option enables the Total Access 600 Series to send the
system identification code in response to a configure acknowledgement from the
peer equipment. For most peer routers this option should be configured as
Y ES
.
If set to N O
, the Total Access 600 Series will accommodate peer routers that do
not correctly respond to the identification code.