ADTRAN 600R - Manual (Page 217)

61200624L1-1B © 2004 ADTRAN, Inc. 215
DLP-12 Loading a Configuration Using XMODEM
Introduction
The Total Access 6XX supports configuration uploads from a unit via the CRAFT interface using a VT100
terminal or terminal emulator (with XMODEM). This DLP provides the steps for a successful
configuration upload using the rear
CRAFT port and XMODEM protocol.
Tools and Materials Required
• VT100 terminal or PC with VT100 terminal emulation software
• XMODEM software
• Appropriate cable to connect terminal to the Total Access 6XX (customer-provided).
• DB-9 female to RJ-48 female adapter (ADTRAN proprietary) for connecting to the CRAFT port on the
rear of the unit (see CRAFT Port on page 31).
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm.
Electronic equipment can be damaged by static electrical discharge. Before handling
modules, put on an antistatic discharge wrist strap to prevent damage to electronic
components. Place equipment in antistatic packing material when transporting or storing.
When working on equipment, always place it on an approved antistatic mat that is
electrically grounded.