ADTRAN 600R User Manual
Page 106
Section 4 User Interface Guide
Total Access 600 Series System Manual
104
© 2004 ADTRAN, Inc.
61200624L1-1B
T
X
M
ETHOD
Specifies the method the Total Access 600 Series uses to obtain PPP
authentication from the peer. There are four possible selections:
N
ONE
The connection will not allow the PPP peer to
authenticate it.
P
AP
, C
HAP
,
OR
E
AP
The unit will ask for EAP during the first PPP LCP
negotiation and allow the PPP peer to negotiate
down to CHAP or PAP.
C
HAP
OR
E
AP
The unit will ask for EAP during the first PPP LCP
negotiation and allow the PPP peer to negotiate
down to CHAP but not PAP.
EAP
ONLY
The unit will only allow EAP to be negotiated. If
the PPP peer is not capable of doing EAP, then
the connection will not succeed.
P
AP
ONLY
The unit will only allow PAP to be negotiated. If
the PPP peer is not capable of doing PAP, then
the connection will not succeed.
R
X
M
ETHOD
Specifies the method the Total Access 600 Series uses to authenticate the PPP
peer. There are four possible selections:
N
ONE
The connection will not allow the PPP peer to
authenticate it.
P
AP
, C
HAP
,
OR
E
AP
The unit will ask for EAP during the first PPP LCP
negotiation and allow the PPP peer to negotiate
down to CHAP or PAP.
C
HAP
OR
E
AP
The unit will ask for EAP during the first PPP LCP
negotiation and allow the PPP peer to negotiate
down to CHAP but not PAP.
EAP
ONLY
The unit will only allow EAP to be negotiated. If
the PPP peer is not capable of doing EAP, then
the connection will not succeed.
P
AP
ONLY
The unit will only allow PAP to be negotiated. If
the PPP peer is not capable of doing PAP, then
the connection will not succeed.
PPP
Configure the PPP specific parameters such as
M
AX
C
ONFIG
,
M
AX
T
IMER
,
M
AX
F
AILURE
,
and
F
ORCE
P
EER
IP
A
DDRESS
from this menu.