Verifying the bridge options – ADTRAN 600R User Manual
Page 184

Section 4 User Interface Guide
Total Access 600 Series System Manual
182
© 2004 ADTRAN, Inc.
61200624L1-1B
3. Verifying the Bridge Options
For more details on the configuration parameters discussed in this section, refer to the following pages:
Bridge menus beginning on
9
Set mode to R
OUTE
IP. Using this menu you also have the option to route only
IP packets and bridge all other data packets (R
OUTE
IP/B
RIDGE
O
THER
) or
bridge all data packets on this connection (B
RIDGE
A
LL
). Refer to L2 Protocol
(ATM–NET–ATM) > Config > PVC Config > Setup (Router) on page 103 for
more details.
10
Left arrow back to the main menu to save the changes.
Bridge Options
Step
Action
1
From the main menu, select B
RIDGE
and press
NTER
>.
2
Use the right arrow key to highlight C
ONFIG
and press
NTER
>.
3
Select I
NTERFACES
and press
NTER
>. Verify that the desired interface is
listed in this table.
4
Left arrow back to the B
RIDGE
> C
ONFIG
menu.
5
Select B
RIDGE
T
ABLE
and set the B
RIDGE
T
ABLE
A
GING
to the desired time (in
minutes) it takes an entry to age out of the Bridge table.
6
Left arrow back to the main menu to save the changes.
Layer 2 Protocol (ATM) Configuration – T1 Interface (Continued)