ADTRAN 600R - Manual (Page 130)

Section 4 User Interface Guide Total Access 600 Series System Manual
128 © 2004 ADTRAN, Inc. 61200624L1-1B
R OUTER > C ONFIG > R OUTES
Configures the default gateway and static routes from this menu.
R OUTER > C ONFIG > R OUTES > D EFAULT G ATEWAY
The default gateway is used by the unit to send IP packets whose destination addresses are not found in the
route table (otherwise known as the gateway of last resort). This is a default gateway for the entire unit, not
just for the Ethernet port. Default is
0.0.0.0. , which configures the Total Access 6XX to use the WAN port
as the default gateway.
R
OUTER
> C
ONFIG
> R
OUTES
> S
TATIC
R
OUTES
Use this menu to enter static routes to other networks.
R
OUTER
> C
ONFIG
> DHCP S
ERVER
Use this menu to set up the DHCP server.
N UM
Displays the index number in the static route table.
A CTIVE
Adds this static route entry to the IP routing table when set to Y ES
and removes it (if it was previously
added) if set to N O
. Default is N O
.
IP A DDRESS
The IP address of the host or network address of the device being routed to. Default is 0.0.0.0 .
S UBNET M ASK
Determines the bits in the previous IP address that are used. If this is to be a host route, it must be set
to all ones (255.255.255.255). Default is
0.0.0.0 .
G ATEWAY
The IP address of the router to receive the forwarded IP packet. Default is 0.0.0.0.
H OPS
The number of router hops required to get to the network or host. Maximum distance is 16 hops.
Default is
1 .
P RIVATE
When set to N O
, the unit will advertise this static route using RIP. Setting to Y ES
means that the route
is kept private. Default is N O
.