ADTRAN 600R - Manual (Page 206)

Section 5 DLP-7 Total Access 600 Series System Manual
204 © 2004 ADTRAN, Inc. 61200624L1-1B
1. Connect to the Total Access 6XX using the 10/100BASET interface.
If you are not already connected to the unit’s ETHERNET port using Telnet client software, use the
procedure in DLP-5, Connecting to the Unit Using Telnet, to connect to the unit.
2. Log in to the unit using the read-write password (see DLP-2, Logging in to the System for details).
3. Verify the TFTP server is running on the network. The user may ping the TFTP server from the Total
Access 6XX to verify communication.
4. Download the firmware upgrade file to your computer.
5. Go to the S YSTEM U TILITY menu and select the U PDATE F IRMWARE menu; press .
6. Go to the T RANSFER M ETHOD menu and select TFTP.
7. Set the TFTP S ERVER A DDRESS to the IP address of the machine running the TFTP server program.
8. Enter the filename of the update file into the TFTP S ERVER F ILENAME field. If the file is located in a
directory other than ADTNUTIL, the entire path and filename are required.
Perform the steps below in the order listed.
A TFTP server ships as part of the ADTRAN Utilities. If using ADTRAN Utilities, choose
S
TART > P ROGRAMS > ADTRAN U TILITIES > TFTP S ERVER to start the server.
If using ADTRAN Utilities, save the upgrade file to the “ADTNUTIL” directory on your
hard drive.
If using ADTRAN Utilities, this will be the IP address that appears in the TFTP S ERVER
S TATUS window.