IEI Integration eKINO-945GSE v1.01 - Manual (Page 32)

eKINO-945GSE Motherboard
Page 16
ƒ Supports the four USB 2.0 devices on the eKINO-945GSE with four UHCI
controllers and one EHCI controller
ƒ Complies with System Management Bus (SMBus) Specification, Version 2.0
ƒ Supports Audio Codec ’97 (AC’97) Revision 2.3
ƒ Supports Intel® High Definition Audio
ƒ Contains Low Pin Count (LPC) interface
ƒ Supports Firmware Hub (FWH) interface
ƒ Serial peripheral interface support
2.5.1 Audio Codec ’97 Controller
The Audio Codec ’97 (AC’97) controller integrated into the Intel® ICH7M complies with
AC’97 Component Specification, Version 2.3. The AC’97 controller is connected to the
following audio jacks on the external connector panel.
ƒ Stereo output
ƒ Microphone input
2.5.2 IDE Interface
The IDE interface connects with
ƒ
2.5.2.1 IDE Connector ........................................................................... 16
ƒ
2.5.2.2 CompactFlash® Slot .................................................................. 17
2.5.2.1 IDE Connector
The IDE connector on the Intel® ICH7M Southbridge connects to an IDE hard disk or
other IDE device. The IDE connector is shown in Figure 2-5.
PIO IDE transfers up to 16 MB/s and Ultra ATA transfers of 100 MB/s. The integrated IDE
interface is able to support the following IDE HDDs:
ƒ Ultra ATA/100, with data transfer rates up to 100 MB/s
ƒ Ultra ATA/66, with data transfer rates up to 66 MB/s
ƒ Ultra ATA/33, with data transfer rates up to 33 MB/s