Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 79)

Operator’s Manual
922700-00 Rev A 73
B
Retrieve the sent ARB sent to your WaveStation as explained in Main
Save/Recall Operations (on page 46), by pressing the Save/Recall Front
Panel button, selecting Data using the FileType operation button, selecting
your waveform on the File display area on the Browser, pressing the Recall
control button.
The waveform you created using the PC Software is now shown in your
WaveStation.
PLEASE NOTE THE FOLLOWING:

A status message should then be shown on the bottom of the Folder
display area indicating the read completed successfully.

A scalar representation of the waveform data is sent. Adjust the
amplitude, frequency, and offset as desired.