Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 33)

Operator’s Manual
922700-00 Rev A 27
B
Creating a Ramp Wave
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Ramp Operation menu and corresponding Display
and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
NOTE: Ramp Operation menu selections and parameters include
Frequency/Period, Amplitude/HLevel, Offset/LLevel, Phase/EqPhase, and
Symmetry. The parameters for Frequency/Period, Amplitude/HLevel,
Offset/LLevel, Phase/EqPhase are carried out the same way as done when creating
a Sine Wave.
With the Ramp waveform and the Symmetry operation button pressed, a
Ramp waveform is shown on the Waveform Display and Symmetry is
shown on the Waveform Detail dialog.
PLEASE NOTE THE FOLLOWING:

Press an adjacent Operation button to select a desired Unit (unit
interval) for your entry.

Provide your desired Symmetry amount using the Digital Input Front
Panel Controls.