Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 36)

WaveStation
30 922700-00 Rev A
Creating a Noise Wave
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Noise Operation menu and corresponding Display
and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
Set Variance/Mean values on Noise Waveforms as follows:
Press the Variance/Mean operation button once to select Variance, a
Noise waveform is shown on the Waveform Display and Variance is shown
on the Waveform Detail dialog.
Press the Variance/Mean operation button a second time to select and adjust
the Mean parameter in the same manner.
PLEASE NOTE THE FOLLOWING:

When using the Number Buttons to edit certain parameters, applicable
unit(s) are shown on the adjacent Units menu. Press a Unit menu button
to select the desired unit for your entry. These units do not appear if you
use the Adjustment Control knob to edit parameter settings.

Provide your desired Variance or Mean values using the Digital Input
Front Panel Controls.
Creating an Arbitrary Waveform
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Arb Operation menu and corresponding Display