Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 73)

Operator’s Manual
922700-00 Rev A 67
B
Making the WaveStation-PC Software Connection
To share waveform data between your WaveStation and a PC:
1. Install the WaveStation PC Software on your the PC you plan to use
with your WaveStation.
2. Enable the USB connector on the Back Panel for a USBRAW
connection by choosing: Utility → IO Setup → USB Setup →
USBRAW.
3. Make the USB cable connection from the Back Panel of the
WaveStation to your PC.
4. On the PC, launch the WaveStation PC Software.
Now your WaveStation and your PC are ready to share waveform data.
Modifying Waveform Files from WaveStation to
PC Software
With your WaveStation - PC Software connection completed as explained
in Making the WaveStation - PC Software Connection (above), you now
need to save Data (Arbitrary Waveform) in one of their 10 specific Memory
Banks on your WaveStation as explained in Main Save/Recall Operations
(on page 46). Otherwise, you can pull one of the many preset Arb files
stored on WaveStation as explained in the Stored Waveforms section of
Creating an Arbitrary Waveform (on page 30).
NOTE: When you save a Data (Arbitrary Waveform) to a Bank/File location already
containing previously stored information, your new information always overwrites
the old.
Now, launch the WaveStation PC Software and select Communication →
Read wave from the menu bar.