Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 71)

Operator’s Manual
922700-00 Rev A 65
B
WaveStation PC Software
Overview
You can use the WaveStation Software to send and receive waveforms files
over a PC connection with your WaveStation. You can make modifications
to Waveform files using the software, save the files, and then see your
changes on your WaveStation.
Topics in this section explain:

Making the WaveStation - PC Software Connection - Connecting to
your WaveStation using your PC and the WaveStation Software

Modifying Waveform Files From WaveStation to PC/Software -
Modify a Waveform on WaveStation, Send it to Your PC, See the
Changes Using the Software

Modifying Waveform Files From PC/Software to WaveStation -
Modify a Waveform on your PC Using the Software, Send it to Your
WaveStation and See the Changes
NOTE: It's important to realize that a scalar representation of the waveform data is
sent. Adjust the amplitude, frequency, and offset as desired.
Minimum PC Software System Requirements

Operating system Microsoft™ Windows® XP, Windows® Vista 32 Bit
Version, Windows® 7 32 Bit Version.

Pentium® IV processor.

1 Gb RAM.

150 Mb hard disk available space for software set‐up.

Video resolution 800 X 600.

USB 2.0 connections.
Updates
Teledyne LeCroy periodically releases software updates for the
WaveStation PC software providing new features, enhancements, and
software corrections. These updates are available free from
telednelecroy.com/support/softwaredownload/.