Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 32)

WaveStation
26 922700-00 Rev A
Creating a Square Wave
When first pressing this waveform button on the Front Panel , the
WaveStation shows the Square Operation menu and corresponding
Display and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
NOTE: Square Operation menu selections and parameters include
Frequency/Period, Amplitude/HLevel, Offset/LLevel, Phase, and Duty Cycle. The
parameters for Frequency/Period, Amplitude/HLevel, Offset/LLevel, Phase are
carried out the same way as done when Creating a Sine Wave.
With the Square waveform and the Duty (Duty Cycle) operation button
pressed, a Square waveform is shown on the Waveform Display and Duty
Cycle is shown on the Waveform Detail dialog.
Duty Cycle is entered as the percentage of the High Level taking up the
whole period.
% of High Level Frequency
20 to 80% < 10 MHz
40 to 60% From 10 MHz to 20 MHz
50% > 20 MHz
PLEASE NOTE THE FOLLOWING:

Press an adjacent Operation button to select a desired Unit (unit
interval) for your entry.

Provide your desired Duty Cycle amount using the Digital Input Front
Panel Controls.