Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 37)

Operator’s Manual
922700-00 Rev A 31
B
and Detail dialogs. There is a System Default Arb Waveform and a User-
Defined Arb Waveform.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
PLEASE NOTE THE FOLLOWING:

Arb Operation menu selections and parameters include
Frequency/Period, Amplitude/HLevel, Offset/LLevel, Phase/EqPhase,
and Load Wform. The parameters for Frequency/Period,
Amplitude/HLevel, Offset/LLevel, and Phase/EqPhase are carried out
the same way as done when creating a Sine Wave.

Operation menus containing more parameters than the ones showing on
the first menu have a 1/X ↓ final selection. The additional menu(s)
therefore have a 2/X ↑ first selection. Press the adjacent button to
navigate additional menu(s) and parameter(s) as desired.
Loading a Stored Waveform is done as follows:
Load Wform

Press the 1/2 ↓ button to access the additional Arb Operation menu.

Now, press the Load Wform button.

An Arb menu showing Built-In and Stored Waveform options is shown.
NOTE: There are 40+ Built-In Arbitrary Waveforms available in the
WaveStation.