Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 27)

Operator’s Manual
922700-00 Rev A 21
B
This section covers details around creating waveforms and making specific
adjustment/selection parameter choices - all of which vary based on the
specific waveform selection made.
For more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
Creating a Sine Wave
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Sine Operation menu and corresponding Display
and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
Sine Operation menu selections and parameters include Frequency/Period,
Amplitude/HLevel, Offset/LLevel, Phase, and Duty Cycle as explained in
the remainder of this topic.
Frequency/Period
With the Sine waveform and the Frequency/Period operation button
pressed once to select Frequency, a Sine waveform is shown on the
Waveform Display and the Frequency is shown on the Waveform Detail
dialog.