Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 68)

WaveStation
62 922700-00 Rev A
Controlling WaveStation with
USB-GPIB and/or USBTMC
WaveStation can be controlled using either USB-GPIB (for GPIB) or USBTMC
(for VISA) protocols. To set the WaveStation to receive the desired
protocol, choose either:

Utility → IO Setup → GPIB.

Utility → IO Setup → USB Setup → USBTMC.
PLEASE NOTE THE FOLLOWING:

For more information, please refer to the WaveStation SCPI
(Standard Commands for Programmable Instruments) Command
Reference Manual available on teledynelecroy.com.

WaveStation requires that remote commands do not contain
termination characters of any kind. This includes Null characters.
About the USB-GPIB Adapter
To use GPIB control, the USB-GPIB Adapter is needed to make the
connection from your PC to your WaveStation.
The USB-GPIB adapter connects the USB host interface on your product to
the GPIB bus controller and command set. The GPIB and USB on the
adapter conforms to IEEE 488.2 and USB 2.0, respectively.

The USB connection provides all necessary power.

LED indicators in the Signal Generator provide an adapter
connection status.

GPIB controls can interface with compatible Teledyne LeCroy
oscilloscopes and, if desired, a GPIB address may be used.
NOTE: The GPIB interface specifically supports Device (and not Controller)
mode.