Teledyne LeCroy WaveStation Waveform Generator Operators Manual User Manual
Page 61
Operator’s Manual
922700-00 Rev A
55
B
Sync - Press this option button and an additional menu is provided
where you can turn the State of your synchronization On/Off and
use the Channel option button to send the synchronized signal to
CH1 or CH2.
All standard output functions (except DC and Noise) have a
corresponding Sync signal sent through the Sync Out connector on
the Back Panel. This can be disabled on certain settings as follows:
o Default - The Sync signal should be connected to the activated
Sync Out connector on the Back Panel. When the Sync Signal is
disabled, the output voltage of the [Sync] connector is set to low
level.
o Inverse - In this mode, the Waveform corresponding to the Sync
Signal does not inverse.
o Non-Modulated Waveforms - The Sync Signal reference is the
carrier signal on non-modulated waveforms.
o AM, FM, and PM - Internal modulating waveforms (AM, FM, and
PM) the Sync signal reference is the modulated signal
o ASK and FSK - The Sync Signal Reference is the keying Frequency.
o Sweep - Once the sweep starts, the Sync Signal becomes TTL Level
High. The Sync frequency equals the specific Sweep time.
o Burst - For the Burst, when the burst starts, the Sync Signal is
Level High.
o External Gated Burst - The Sync Signal follows the External Gated
Signal.
o Pulse - The Sync Signal is a Pulse Signal with a fixed positive pulse
width more than 50 ns.
ChCopy - Press this option button and an additional menu is
provided where you can port a particular channel's configuration to
another. Option buttons are labeled as CH1->CH2 and CH2->CH1
accordingly.
Make selections as desired and press the Done (to commit) or Cancel
option button and the main Util menu is shown.