Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 23)

Operator’s Manual
922700-00 Rev A 17
B
Save/Recall, Utility, and Help Buttons

Save/Recall - Press the Save/Recall button to store or arrange waveform
data either on the WaveStation itself or on an external memory device.
This function is also used for retrieving data previously stored on internal
or external memory as well.

Utility - Press the Utility button to set Auxiliary System Functions,
Output Parameters, Interface Settings, and to View System Setting
Information.

Help - Press the Help button and the WaveStation help system is
pertaining to the current function or operation is shown.
Combined Use of Waveform, Function, and
Configuration Buttons
Main Waveform Buttons
As mentioned in Waveform Types and Default Parameters (on page 15),
provided your WaveStation is powered on, a single waveform type is
always selected and only one waveform type is selected at a time.
Waveform Signal Conditioning Function Buttons
As mentioned in Initial Function Settings (on page 16), you apply one of the
three signal conditioning function buttons to your selected waveform type
for specific Mod, Sweep, or Burst functionality.
Menus are therefore displayed in a prioritized order of Waveform Type
(one of which is always selected) and a second level of Mod, Sweep, or
Burst (one of the three at a time). However, it is not mandatory to apply
Mod, Sweep, or Burst functionality to your selected waveform. Therefore,
a second press of the Mod, Sweep, or Burst button turns the LED and
function off to reveal the originally selected waveform type menu.