Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 60)

WaveStation
54 922700-00 Rev A
WaveStation PC Drivers and Software (on page 66). Be sure to make
the USBTMC setting before connecting to WaveStation from a
PC using VISA. Download the latest copy of NI-VISA at
www.ni.com/visa/.

Press the GPIB option button and use the Adjustment Control Knob
from the Digital Input Front Panel Controls to provide a specific GPIB
Address value. This GPIB enables the USB connector on the Front
Panel of your instrument.

NOTE: Be sure to make the correct GPIB Address setting before
connecting to WaveStation from a PC using the USB-GPIB Adapter . The
USB connector on the Front Panel is also used for USB memory sticks .
USB memory sticks are plug-and-play supported and no special
setting is needed for their use.

Make selections as desired and press the Done (to commit) or
Cancel option button and the main Util menu is shown.
Output Setup
Press this option button and an additional menu is shown.
Use these additional output controls for the following:

Load/HighZ - Use this option button to select either Load or HighZ
for your waveform output.

Normal/Invert - Use this option button to select either Normal or
Invert for your waveform output.