Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 34)

WaveStation
28 922700-00 Rev A
Creating a Pulse Wave
When first pressing this waveform button on the Front Panel, the
WaveStation shows the Pulse Operation menu and corresponding Display
and Detail dialogs.
Press adjacent Operation buttons and use the Digital Input Front Panel
Controls to make specific adjustment/selection parameter choices. For
more information on getting to this point, see Navigating Interfaces,
Adjusting Parameters, and Making Selections (on page 11).
NOTE: Pulse Operation menu selections and parameters include Frequency/Period,
Amplitude/HLevel, Offset/LLevel, PulWidth/Duty, and Delay. The parameters for
Frequency/Period, Amplitude/HLevel, and Offset/LLevel are carried out the same
way as done when creating a Sine Wave.
PulWidth/Duty
With the Pulse waveform and the PulWidth/Duty operation button
pressed once to select PulWidth, a Pulse waveform is shown on the
Waveform Display and the Pulse Width is shown on the Waveform Detail
dialog.
Positive Pulse Width is the time from the first rising edge to the first falling
edge, Similar to Negative Pulse Width.
PLEASE NOTE THE FOLLOWING:

Press an adjacent Operation button to select a desired Unit (unit
interval) for your entry.

Provide your desired PulWidth amount using the Digital Input Front
Panel Controls.