Teledyne LeCroy WaveStation Waveform Generator Operators Manual - Manual (Page 59)

Operator’s Manual
922700-00 Rev A 53
B
Utility Operation Menu Selections and Parameters
The following operations are available from the Util menu option buttons.
Some are explained in the remainder of this section. Where necessary,
even more detail is provided in subsequent topics to clearly explain their
proper use.
DC
The DC switch offers the options of direct current output (On) or Arbitrary
Waveform Output (Off). Pressing the option button turns the DC On and
shows an additional menu where you can quickly select a 1/-1V or 2/-2V
DC Offset using corresponding option buttons.
NOTE: After pressing either 1/-1V or 2/-2V DC Offset option buttons, the
Adjustment Control Knob may also be used to dial in the desired level within a -3
to 3V range.
IO Setup
After pressing the IO Setup option button, an additional menu is shown
where you can set USB or GPIB input/output options.

Press the USB Setup option button and an additional menu is shown
where you can choose either USBRAW or USBTMC options by
pressing corresponding option buttons for the USB connector on the
Back Panel of your WaveStation.

NOTE: Be sure to make the USBRAW setting before connecting to
WaveStation from a PC using the WaveStation PC Software. For
more detailed installation instructions, see Installing the