Errors, External signals, Errors external signals – Teledyne LeCroy USB Chief - Users Manual User Manual

Page 42

Text mode
Original mode

Chief User’s Manual

CATC

Version 1.7

Errors

Step 1

Select Errors under Event Groups.

Step 2

Use any combination of the listed packet/signaling/protocol errors as a
Trigger.

External Signals

Step 1

Select External Signals under Event Groups.

Step 2

If desired, use pins 10-14 on the USB Chief Breakout Board as Trigger
Inputs for the Analyzer from your hardware. If you hook up any of these
pins, you must check the corresponding Trigger Input number in this
Event Group to enable it as a Trigger.

Step 3

If desired, enable or disable Trigger Inputs 0 through 4 from the External
Interface Breakout Board. These inputs may also be set as Active-Low
or Active-High signals.