Teledyne LeCroy USB Chief - Users Manual - Manual (Page 15)

7
Chief User’s Manual CATC Version 1.7
Chapter 3: Upgrades
From time to time as modifications are made to the Analyzer, it is necessary to
update the Chief for optimal performance. These changes require that you be
familiar with the procedures for updating the three portions of the Analyzer: the
software, the firmware, and the BusEngine. If you haven’t already done so, you
may also want to upgrade from USB Chief to Chief Plus so that you can use your
Analyzer to generate traffic.
You can check the version of USB Chief you are running by selecting About USB
Chief from the Help menu.
Software Upgrades
When a new software release is available, it is posted on the Support page of the
CATC website at www.catc.com/support.html.
To update the software, follow these steps:
Step 1 In the About USB Chief screen, verify which version of USB Chief
Software you are currently running.
Step 2 Find the latest released software version on the CATC website under
Support.
If you are running the latest version of the software, no further action is
needed.
If you are not running the latest version, continue to Step 3.
Step 3 Click on the first link to download the zipped Disk 1 files for your
operating system.
Step 4 Click on the second link to download the zipped Disk 2 files.
Step 5 Unzip the files into your choice of directory.
Step 6 Click Start, then Run, and browse to where you unzipped the files.
Step 7 Select the program named Setup and click Open.
Step 8 Click OK to run the Setup and begin the installation.
Step 9 Follow the on-screen instructions to complete the installation.
Step 10 Read the Readme file for important information on changes in the
release.