Teledyne LeCroy USB Chief - Users Manual - Manual (Page 29)

21
Chief User’s Manual CATC Version 1.7
• Microsoft Windows 95 or any later Windows system, including NT4.0, for
viewing traffic only
• Minimum of 16MB physical RAM; 32 MB recommended for viewing
transactions
• At least 10 MB hard disk space, plus additional memory for recordings (as
much as 200MB when recording a full buffer size)
• Monitor resolution at least 800x600 with thousands of colors
USB Chief Program Installation
The CATC USB Chief software is provided on two 3½ inch diskettes and requires
a Windows 95 (OSR 2.1), Windows 98, Windows 98SE, or Windows 2000
operating system.
Note The USB Chief program also operates on earlier versions of Windows 95 or
Windows NT (4.0) systems in a Trace View mode. That is, it may be used to view,
analyze, and print data that was collected and saved on another system.
There are different installations for Windows 95 and Windows 98/2000 because
of the difference in the Plug-and-Play drivers that automatically load when an
active USB device is detected. Use the diskette(s) appropriate for the operating
system on your computer.
Loading the USB Chief Drivers
Step 1 Insert the USB Chief program floppy for your operating system labeled
Disk 1 of 2 into the a: drive.
Step 2 Power-on the USB Chief Analyzer.
Step 3 Connect the USB cable to the rear of the Analyzer and to the personal
computer.
The host operating system detects the Analyzer and begins to install the
driver.
Step 4 Follow the installation instructions provided on your screen and insert
the USB Chief program floppy labeled Disk 2 of 2 into the a: drive when
prompted.
Note When Windows prompts you for a file, browse to the CATC floppy in the a: drive.
Installing the USB Chief Program
Step 1 Insert the USB Chief program floppy into the a: drive on your computer.
Step 2 Click Start.
Step 3 Click Run.