IAI America RCA-E - Manual (Page 19)

P. 16
Use either the Return Key or Key to execute content of the transfer. Use either of Keys for positon number
changes. In the display screen, only the single content of one position number will be displayed.
The position table main display area is divided into 4 screens and is displayed as below.
You can change the screens by using the arrow keys ( ).
* MDINumerically inputs the position data directly from the ten key (input example: Page 21 in this manual).
* Add
Adds the position data into the assigned position data number (input example: Page 25 in this manual).
* Delete Deletes position data (input example: Page 26 in this manual).
* Clear Resets the position data (input example: Page 27 in this manual).
* All Clear Resets all of the 16 position data.
The position data table will display by selecting and determining MDI
As the table below shows, in the position table, there are 7 setting contents (position, speed, ACC • DEC, Push %,
Range, ACC MAX and ABS/INC) per each position data:
8. Operation
M D I N o. 0 0 A. 0 0
P o s i t i o n A *
Numbers following “No.” indicate the position number.
The numbers following “A.” indicate the axis number.
Indicates the following:
A : ABS (Absolute Coordinate Assign)
I : INC (Absolute Coordinate Assign)
No. Position Speed ACC • DEC Push % Range ACC MAX ABS/INC
0 * *mm/s *G *% *mm * 0
1 * *mm/s *G *% *mm * 0
2 * *mm/s *G *% *mm * 0
3 * *mm/s *G *% *mm * 0
4 * *mm/s *G *% *mm * 0
5 * *mm/s *G *% *mm * 0
6 * *mm/s *G *% *mm * 0
7 * *mm/s *G *% *mm * 0
8 * *mm/s *G *% *mm * 0
9 * *mm/s *G *% *mm * 0
10 * *mm/s *G *% *mm * 0
11 * *mm/s *G *% *mm * 0
12 * *mm/s *G *% *mm * 0
13 * *mm/s *G *% *mm * 0
14 * *mm/s *G *% *mm * 0
15 * *mm/s *G *% *mm * 0
Position Data Table