IAI America RCA-E - Manual (Page 16)

P. 13
Using the Keys, select the data inputting axis (controller),
and determine with the Return Key. Only the connecting axis will
be displayed.
8. Operation
8-2 Controller Selection (when using multiple units)
In case of multiple units connected serially via the RS485 communication line, the axis selection screen will be
displayed. For a single unit, since there is no need to select the axis, the first screen below will not appear (refer to
Section 8.3 entitled Operational Mode Selection of this manual). The content explained here will be based on operation
of the selected axis (controller). In addition, the controller can connect up to 16 units.
From here on, the content explained will be based on operation against the axis (controller) selected here.
Caution:
If power is supplied with the PORT switch ON and power is present on the teaching pendant,
only powered controllers will be detected.
The content explained hereupon will be based on operation against selected axis (controller).
Axis Select
* Axis No. 00
Axis Select
* Axis No. 0 1
Axis Select
* Axis No. 02
Axis No. 1
•
•
•