Agilent Technologies L4400 - Manual (Page 125)

L4433A Dual/Quad 4x8 Reed Matrix 5
L4400 User’s Guide 113
L4433A SCPI Command Summary
Table 5- 1 lists the instrument- specific SCPI commands that apply to the
L4433A Dual/Quad 4x8 Reed Matrix. Table 3- 3 (Chapter 3) lists the SCPI
commands that apply to all L4400 series instruments.
For complete information on all SCPI commands, refer to the
Programmer’s Reference contained on the L4400 Product Reference
CD- ROM (p/n 34989- 13601).
Table 5-1. L4433A SCPI Command Summary
Subsystem Commands
ROUTe
(Switch Control)
ROUTe:CHANnel:LABel:CLEar:MODule 1
ROUTe:CHANnel:LABel[:DEFine] "" , (@)
ROUTe:CHANnel:LABel[:DEFine]? [{USER|FACTory},]
(@)
ROUTe:CLOSe (@)
ROUTe:CLOSe? (@)
ROUTe:CLOSe:EXCLusive (@)
ROUTe:MODule:BUSY? 1
ROUTe:MODule:WAIT 1
ROUTe:MODule:WAIT? 1
ROUTe:OPEN (@)
ROUTe:OPEN? (@)
ROUTe:OPEN:ABUS {1-4|ABUS1-ABUS4|ALL}
ROUTe:OPEN:ALL 1
ROUTe[:OPERation]:OVERlap[:ENABle] {OFF|0|ON|1}
ROUTe[:OPERation]:OVERlap[:ENABle]?
ROUTe
(Sequence
Operation)
ROUTe:SEQuence:ABORt
ROUTe:SEQuence:BUSY?
ROUTe:SEQuence:CATalog?
ROUTe:SEQuence:DEFine , ""
ROUTe:SEQuence:DEFine?
ROUTe:SEQuence:DELete:ALL
ROUTe:SEQuence:DELete[:NAME]
ROUTe:SEQuence:RUNNing:NAME?
ROUTe:SEQuence:TRIGger[:IMMediate]
ROUTe:SEQuence:TRIGger:SOURce , MANual
ROUTe:SEQuence:TRIGger:SOURce?
ROUTe:SEQuence:WAIT
SYSTem SYSTem:MODule:WIRE:MODE {WIRE1|WIRE2}, 1

SYSTem:ABUS:INTerlock:SIMulate {OFF|0|ON|1}
SYSTem:ABUS:INTerlock:SIMulate?
DIAGnostic DIAGnostic:RELay:CYCLes? (@)
DIAGnostic:RELay:CYCLes:CLEar (@)