5 serial port setup – Micromod MOD: MODCELL Application Builder Software User Manual
Page 34
Application Builder
TOOLBAR REFERENCE
4.5
SERIAL PORT SETUP
Select the Serial Port Setup icon to establish the type of communication used
between your personal computer and the instruments. The setup display
allows for independent configuration of four communication ports.
Link
Baud
Data
Bits
Stop
Bits
Parity
1720N
19200, 9600, 4800, 2400,
1200
8
1, 2
None, Even, Odd
1731N
19200, 9600
8
1
None
1733N
19200, 9600, 4800, 2400,
1200, 600, 300
8
1
None
None
38400,19200, 9600, 4800,
2400, 1200, 600, 300,150
8
1,2
None, Even, Odd
In most cases the address (Hex number) can be left unchanged. A zero
will appear if the software cannot determine the address. Enter the
correct address if a zero appears or if your computer uses a different
address than that determined through the software check of your
computer’s BIOS.
2.
Select the baud rate, data bits, parity, and stop bits that match the device
with which you are communicating.
1.
Select the the
communication port
your wish to use.
Communication
parameters are saved
in the file SIO.DAT,
which is created if it
does not exist. At this
time, the software
attempts to determine
the base address of
each communication
port.
Comm
Type
ICN
Modbus
4-4