B&K Precision 2552-2559 - Programming Manual - Manual (Page 9)

9
RCPN RECALL_PANEL SAVE/RECALL
Recalls a front-panel setup
from mass storage.
*RST *RST SAVE/RECALL
The *RST command
initiates a device reset.
REFS REF_SET FUNCTION
Sets the reference
waveform and its options.
*SAV *SAV SAVE/RECALL
Stores current state in non-
volatile internal memory.
SCDP SCREEN_DUMP HARD COPY
Causes a screen dump to
controller.
SCSV SCREEN_SAVE DISPLAY
Controls the automatic
screen saver.
*SRE *SRE STATUS
Sets the Service Request
Enable register (SRE).
*STB? *STB? STATUS
Reads the contents of
IEEE 488.
STOP STOP ACQUISITION
Immediately stops signal
acquisition.
STO STORE WAVEFORMTRANS
Stores a trace in internal
memory or mass storage.
STPN STORE_PANEL SAVE/RECALL
Stores front-panel setup to
mass storage.
STST STORE_SETUP WAVEFORMTRANS
Controls the way in which
traces are stored.
SAST SAMPLE_STATUS ACQUISITION
Return the acquisition
status of the scope
SARA SAMPLE_RATE ACQUISITION
Return the sample rate of
the scope
SANU SAMPLE_NUM ACQUISITION
Return the number of
sampled points available
from last acquisition and
the trigger position
SKEW SKEW ACQUISITION
Sets the skew of specified
trace.
SET50 SETTO%50 FUNCTION
Sets the trigger level of the
trigger source to the centre
of the signal amplitude.
SXSA SINXX_SAMPLE ACQUISITION
Sets the type of the
interpolation.
TDIV TIME_DIV ACQUISITION
Modifies the time base
setting.
TMPL TEMPLATE
WAVEFORM
TRANSFER Produces a complete
waveform template copy.
TRA TRACE DISPLAY
Enables or disables the
display of a trace.
*TRG *TRG ACQUISITION Executes an ARM