B&K Precision 2552-2559 - Programming Manual - Manual (Page 10)

10
command.
TRCP TRIG_COUPLING ACQUISITION
Sets the coupling mode of
the specified trigger
source.
TRDL TRIG_DELAY ACQUISITION
Sets the time at which the
trigger is to occur.
TRLV TRIG_LEVEL ACQUISITION
Adjusts the trigger level of
the specified trigger
source.
TRMD TRIG_MODE ACQUISITION the trigger mode.
TRSE TRIG_SELECT ACQUISITION
Selects the condition that
will trigger acquisition.
TRSL TRIG_SLOPE ACQUISITION
Sets the trigger slope of
the specified trigger
source.
UNIT UNIT ACQUISITION
Sets the unit of specified
trace.
VPOS VERT_POSITION DISPLAY
Adjusts the vertical
position of the FFT trace.
VDIV VOLT_DIV ACQUISITION
Sets the vertical
sensitivity.
VTCL VERTICAL ACQUISITION
Controls the vertical
position of the slope
trigger line.
WF WAVEFORM WAVEFORMTRANS
Gets the waveform from
the instrument.
WFSU WAVEFORM_SETUP WAVEFORMTRANS
Specifies amount of
waveform data to go to
controller.
WAIT WAIT ACQUISITION
Prevents new analysis
until current has been
completed.
XYDS XY_DISPLAY DISPLAY
Enables or disables to
display the XY format