B&K Precision 2552-2559 - Programming Manual - Manual (Page 5)

5
Table of Commands & Queries
Short Form Long Form Subsystem
What the Command or
Query Does
ALST? ALL_STATUS? STATUS
Reads and clears
the contents of all
status registers.
ARM ARM_ACQUISITION ACQUISITION
Changes acquisition state
from “stopped” to
“single”.
ATTN ATTENUATION ACQUISITION
Selects the vertical
attenuation factor of the
probe
ACAL AUTO_CALIBRATE MISCELLANEOUS
Enables or disables
automatic calibration.
ASET AUTO_SETUP ACQUISITION
Adjusts vertical, time base
and trigger parameters.
AUTTS AUTO_TYPESET ACQUISITION
Selects the display type of
automatic setup.
AVGA AVERAGE_ACQUIRE ACQUISITION
Selects the average times
of average acquisition.
BWL BANDWIDTH_LIMIT ACQUISITION
Enables/disables the
bandwidth-limiting low-
pass filter.
BUZZ BUZZER MISCELLANEOUS
Controls the built-in
piezo-electric buzzer.
*CAL? *CAL? MISCELLANEOUS
Performs complete
internal calibration of the
instrument.
CHDR COMM_HEADER COMMUNICATION
Controls formatting of
query responses.
*CLS *CLS STATUS
Clears all status data
registers.
CMR? CMR? STATUS
Reads and clears the
Command error Register
(CMR).
CONET COMM_NET COMMUNICATION
Specifies network
addresses of scope and
printers.
CPL COUPLING ACQUISITION
Selects the specified input
channel’s coupling mode.
CRMS CURSOR_MEASURE CURSOR
Specifies the type of
cursor/parameter
measurement.