B&K Precision 2552-2559 - Programming Manual - Manual (Page 112)

112
DESCRIPTION The TRACE command enables or disables the
display of a trace. An environment error is set if
an attempt is made to display more than four
waveforms.
The TRACE? query indicates whether the
specified trace is displayed or not.
COMMAND SYNTAX
: TRAce
: = {C1, C2, C3, C4, TA, TB, TC, TD}
: = {ON, OFF}
QUERY SYNTAX
: TRAce?
RESPONSE FORMAT : TRAce
EXAMPLE
The following command displays Channel 1 (C1):
Command message:
C1: TRA ON
DISPLAY TRACE, TRA
Command /Query