B&K Precision 2552-2559 - Programming Manual - Manual (Page 77)

77
DESCRIPTION The PARAMETER_VALUE query returns the
measurement values.
Parameters Available on All Models
ALL all parameters NDUTY negative duty cycle
AMPL amplitude NWID negative width
BASE base OVSN negative overshoot
CMEAN mean for cyclic
waveform OVSP positive overshoot
CRMS root mean square for
cyclic part of waveform PKPK peak-to-peak
DUTY duty cycle PER period
FALL falltime RPRE (Vmin-Vbase)/ Vamp
before the waveform
rising transition
FREQ frequency PWID positive width
FPRE (Vmin-Vbase)/ Vamp
before the waveform
falling transition RMS root mean square
MAX maximum RISE risetime
MIN minimum TOP top
MEAN mean WID width
QUERY SYNTAX : PArameter_VAlue? [, ... ,
]
: = { C1, C2, C3, C4}
: = See table of parameter names
on previous table.
RESPONSE FORMAT : PArameter_VAlue ,
[, ... , ,]
EXAMPLE The following query reads the risetime of
Channel 2
Command message:
C2: PAVA? RISE
Response message:
C2: PAVA RISE, 3.6E-9S
CURSOR PARAMETER_VALUE?, PAVA?
Query