B&K Precision 2552-2559 - Programming Manual - Manual (Page 18)

18
DESCRIPTION BANDWIDTH_LIMIT enables or disables the
bandwidth-limiting low-pass filter. If the bandwidth
filters are on, it will limit the bandwidth to reduce
display noise. When you turn Bandwidth Limit ON,
the Bandwidth Limit value is set to 20 MHz. It also
filters the signal to reduce noise and other unwanted
high frequency components.
The response to the BANDWIDTH_LIMIT? Query
indicates whether the bandwidth filters are on or off.
COMMAND SYNTAX BandWidth_Limit ,
[, , [, ,
[, , ]]]
: = {C1, C2, C3, C4}
: = {ON, OFF}
QUERY SYNTAX BandWidth_Limit?
RESPONSE FORMAT
BandWidth_Limit , [, ,
[, , [, ,
]]]
EXAMPLE The following turns on the bandwidth filter for all
channels, when Global_BWL is on (as it is by default
The following turns the bandwidth filter on for
Channel 1only:
Command message:
BWL C1, ON
ACQUISITION BANDWIDTH_LIMIT, BWL
Command /Query