B&K Precision 2552-2559 - Programming Manual - Manual (Page 26)

26
DESCRIPTION The COUPLING command selects the
coupling mode of the specified input channel.
The COUPLING? query returns the coupling
mode of the specified channel.
COMMAND SYNTAX
: CouPLing
: = {C1, C2, C3, C4}
: = {A1M, A50, D1M, D50, GND}
The A of the is alternating current.
The D of the is direct current.1M
and 50 is the impedance of input. Some series
(CML) couldn’t have the set of input
impedance.
QUERY SYNTAX : CouPLing?
RESPONSE FORMAT
: CouPLing
EXAMPLE
The following command sets the coupling of
Channel 2 to 50 ΩDC:
Command message:
C2: CPL D50
ACQUISITION COUPLING, CPL
Command /Query