Extron Electronics DMP 128 User Guide - Manual (Page 22)

DsP configurator Program Basics
starting the Program
notE: Extron recommends connection via the Ethernet LAN port for running the
DSP Configurator program.
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator.
DSP Configurator starts in Emulate mode (see figure 13, next page). Also see Emulate
mode and Live mode on page 89.
using the Program
In the DSP Configurator Emulate mode, audio parameters can be selected, then
transferred to the DMP 128 by switching to Live mode (while connected to a DMP 128)
and pushing the configuration. Audio settings can also be tailored while connected to the
DMP 128 for real-time auditioning of the audio output as adjustments are made
(see
Emulate mode and Live mode on page 89).
The main screen contains controls for the input and output channels, virtual sends and
returns, expansion outputs and inputs, and other information used in the operation of the
DMP 128. There is too much information contained on the main screen to enable viewing
of the entire mix board at one time, so several methods, outlined on the following pages,
are provided to scroll through the screen.
DMP 128 • Software Control 16