Extron Electronics DMP 128 User Guide - Manual (Page 103)

DsP configurator windows Menus
Keyboard navigation
DSP Configurator is fully navigable using the computer keyboard. Some keyboard
navigation behavior matches Windows standards, while other behaviors are specific to
DSP Configurator.
jumps to the various sections outlined in red in figure 61, below. When the program
starts, the cursor defaults to the Emulate button (a). Press to jumps focus to the
next area, then the next, in order.
Within the sections, the move one processor block or mix-point right,
left, up, or down within the section.
Virtual Returns
Expansion Returns
Exp. Inputs 1 - 8
Exp. Inputs 9 - 16
Outputs
Inputs
m n o l r
k
p
q
d
f
c e b a g
h
i j
Figure 61. DSP Configurator Program
standard windows navigation
The keyboard keys navigate and function as follows:
• Tab key —
Sequentially jump among major segments of the DSP Configurator program. From the
Emulate mode button (a), sequential jumps are in the following order:
b Live mode k Virtual Returns minimize button
c Presets (Down arrow can select presets) l Virtual Return signal path (defaults to FBS)
d Outputs minimize button m Virtual Return bus mix-points
e Output signal path (defaults to trim) n Virtual Return bus to Virtual sends
f Input minimize button o Virtual Return bus to EXP sends
g Input signal processing (defaults to gain) p EXP Returns bus minimize button
h Main mix-points q EXP Inputs bus 1-8 maximize button
i Virtual Send bus mix-points r EXP Inputs bus 9-16 maximize button
j Expansion Send bus mix-points
DMP 128 • Software Control 97