Extron Electronics DMP 128 User Guide - Manual (Page 121)

Dante Device Discovery
The Tools menu also provides a way to locate other Dante devices on your network. Once
the device is named (see
Dante Network Audio Setup on page 113), it can easily be
identified as a Dante host from any other Dante device.
To locate Dante devices on an audio network:
1. Select Tools>Device Settings. The
Device Settings dialog opens.
2. Select the Dante Device tab.
3. Dante devices are found by either:
a. Entering the name in the AT name: field,
-or-
b. Click Search for Dante components
to start a search.
The search may take a few minutes.
As new devices are discovered, they are listed
in the window.
4. If you are using the EXP port to connect to
a non AT DMP 128, check the Use Extron
Expansion Bus for channels 41-56 box
(see Using the Extron Expansion Bus with
DmP 128 AT Devices on page 125).
5. Click Apply or OK.
DMP128MASTER
Dante Device
Search for Dante Components
To identify your AT component, enter the
name below or click the button below to
search your local network.
AT name:
DMP 128 • Software Control 115