Extron Electronics DMP 128 User Guide User Manual
Page 169
7.
Click Next (see figure 91, g on the previous page). The program extracts and places
the firmware files in a folder identified in the InstallShield Wizard dialog box.
notE: The download folder can change depending on the operating system.
Note the folder where the firmware file is saved.
8.
Click Finish (figure 91,
h
) to exit the program.
9.
Connect the PC to the DMP 128 via the Ethernet port.
10.
Access the device using the HTML pages (see
11.
Click the Configuration tab (see figure 92) to open the configuration page.
12.
Click the Firmware Upgrade link on the
System
Configuration
page.
The current firmware version is displayed above the upload field for reference.
Firware Upgrade
Passwords
System Settings
11
12
Current Firmware Version: 1.02
Figure 92.
Firmware Upgrade Page
13.
Click Browse. An
Open
File
dialog box opens.
14.
Navigate to the firmware file folder noted in step 7, and select the firmware file.
notE: Valid firmware files must have the file extension ‘.S19’. Any other file
extension is
not a firmware upgrade. The original factory-installed firmware is
permanently available on the device. If the attempted firmware upload fails for
any reason, the device automatically reverts to the factory-installed firmware.
15.
Click Open.
16.
Click Upload. The firmware upload to the device can take a few minutes.
DMP 128 • HTML Operation
163