V-Tech CAT5 System Technical Guide - Manual (Page 78)

Page 78 K5 System Technical Guide
Work with C5-F414
Note:
1. SW1 need to be set to F4Q position to match with C5-F414.
2. S1 need to be set correctly, Bit2 to ON, the rest to OFF.
3. Door station need to be connected to the JWB (IN) port of C5-IPC.
4. DS Serial NO. must not be set to 0(while 0 to be the controller).
1
2
3
4
C5-AT27
PS5
1 2 3
6 5 4
7 8 9
# 0 *
RF CARD
CN1 CN2
CN-LK
J/KMB JP-LK
Bus EB+ EB- N.O LK+ LK- +12V
1 2 3
T/R- T/R+
1 2 3
SW1
PA VR600
+
S1 POWER
LINK IN-USE
AG
1
ON
ON
DIP
DIP
2 3 4 5 6
1 2 3
SW1
C5-IPC
C5-F414
IP-MR18
AC
+ -
+ -
+ -
To other monitors
PS5
AC + -
1R 2W
GD VD T/R+ T/R- Z1 Z2 Z3 Z4 COM COM PR
3Y 4B FV+ FV- P- AU P- P+ P+ D1&D2
To Next C5-F414
F4/F4DV/F4Q Keep 3 jumpers
LAN
CAT5
RVV2*1.0mm
Note that ID Code(#8001-1) setting in MR18 must be set to 1
PORT-A PORT-B PORT-C PORT-D JWB(IN) JWB(OUT)
VD-SET(L=HIGH)
P- P+ P- P+ PA S1
1
ON
2
T/R- ERROR INUSE LINK POWER T/R+
PORT-A PORT-B PORT-C PORT-D JWB(IN) JWB(OUT)
+ -
P- P+ P+ P-
VD-SET
HI / VD
1
2
3
4
C5-AT27
C5-F414
To other monitors
1R 2W
GD VD T/R+ T/R- Z1 Z2 Z3 Z4 COM COM PR
3Y 4B FV+ FV- P- AU P- P+ P+ D1&D2
PORT-A PORT-B PORT-C PORT-D JWB(IN) JWB(OUT)
VD-SET(L=HIGH)
P- P+ P- P+ PA S1
1
ON
2
T/R- ERROR INUSE LINK POWER T/R+
PORT-A PORT-B PORT-C PORT-D JWB(IN) JWB(OUT)
+ -
P- P+ P+ P-
VD-SET
HI / VD
+ -
+ -
To Next PS5
A single cable to connect
P-(Ground) together
Note that VD-SET must be set to VD if the C5-F414 is the last one of the bus
HI / VD
P+ P- P+ P- RS485 JWB(IN) JWB(OUT) CN(MDS) ETHERNET
P+ P+ P- RS485 JWB(OUT) ETHERNET JWB(IN) P- CN(MDS)
Chapter 4 K5 System Settings