V-Tech CAT5 System Technical Guide - Manual (Page 53)

Page 53 K5 System Technical Guide
• Unlock by code(Debug State->1#->1. Installer Setup->7. Parameters)
• Unlock code setting (Debug State->1#->2. Setup->4. Unlock code)
If Door Station runs as Debug State, you can press “1#” then “2 “to enter Setup to make configure
unlock setting;
However, if runs as Normal State, follow these steps to enter:
• Proximity Cards operation
This part explains how to configure the Proximity card access function, by means of keypad.
Please note, to a Door Station without access security, all the related parameters can’t be updated.
The capacity for cards in IP-MR6L/IP-MR9L is 1000. If door station is used with C5-IPC, cards can
be stored in C5-IPC ,the memory of C5-IPC can be upgraded to 10,000 cards if needed. It is much
convenient to manage access security and cards by means of IP-Device software in a networked
system. Reading distance is approximately 30mm from the window.There are 2 type of setup, for
Access controller and cards authorization.
Door Station should enter Debug State first, and then operate as below:
When Door Station is
standby, press “#” key
Press “#” key, Input “8002”,
then input Setup Code or
Admin Code (88888888 or
66666666 by default)
Input 4 digits Unlock Code
Press “4” to enter unlock
code item.
If verified correctly,
door open
Input 4 digits number,
then press “#” to update
[ **** ]
Please Input Password
1 2 3 6 5 4
7 8 9 # 0 *
RF CARD
1 2 3 6 5 4
7 8 9 # 0 *
RF CARD
i
*Back
[ - - - - ]
( * * * *)
# Save
4 . U n l o c k C o d e [ 1 1 1 1 ]
[ **** ]
Please Input Password
1 2 3
6 5 4
7 8 9 # 0 *
RF CARD
1 . L a n g u a g e [ 1 ]
2 . To n e S e l e c t [ 0 3 ]
3 . To n e V o l u m e [ 0 3 ]
5 . D i s p l a y M o d e
6 . C l o c k
7 . S e t u p C o d e
8 . A b o u t
9 . D e f a u l t
Press No.
to select
*Back
Setup
4 . U n l o c k C o d e [ 1 1 1 1 ]