V-Tech CAT5 System Technical Guide - Manual (Page 76)

Page 76 K5 System Technical Guide
4.4.2.6§Examples:
Work with C5-F4
C5-F4
C5-F4
1
2
3
4
1R 2W
GD VD T/R+ T/R- Z1 Z2 Z3 Z4 COMCOMPR
3Y 4B FV+FV-P- AU P- P+ P+ D1&D2
C5-AT27
PS5
1 2 3
6 5 4
7 8 9
# 0 *
RF CARD
CN1 CN2
CN-LK
J/KMB JP-LK
Bus EB+ EB- N.O LK+ LK- +12V 1 2 3
T/R- T/R+
1 2 3
P+ P- P+ P- RS485
SW1
JWB(IN) JWB(OUT) CN(MDS) ETHERNET
PA VR600
+
S1 POWER
LINK
IN-USE
AG
1
ON DIP
2 3 4 5 6
1 2 3
P+ P- P+ P- RS485
SW1
JWB(IN) JWB(OUT) CN(MDS) ETHERNET
C5-IPC
IP-MR18
AC
+ -
+ -
+ -
To other monitors
PS5
AC + -
+ -
C5-F4
C5-F4
1
2
3
4
1R 2W
GD VD T/R+ T/R- Z1 Z2 Z3 Z4 COMCOMPR
3Y 4B FV+FV-P- AU P- P+ P+ D1&D2
C5-AT27
To other monitors
+ -
To Next C5-F4
F4/F4DV/F4Q
ON DIP
Keep 3 jumpers
LAN
Note that VD-SET must be set to 120 if the C5-F4 is the last one of the bus
HI
120
HI
120
HI
120
Note that ID Code(#8001-1) setting in MR18 must be set to 1
CAT5
RVV2*1.0mm
Note:
1. SW1 need to be set to F4 position to match with C5-F4.
2. S1 need to be set correctly, all to OFF.
3. Door station need to be connected to the JWB (IN) port of C5-IPC.
4. DS Serial NO. must not be set to 0(while 0 to be the controller)
Chapter 4 K5 System Settings