Code number: [ 1 002, 3§address§setting§with§door§station, Chapter 4 k5 system settings – V-Tech CAT5 System Technical Guide User Manual
Page 68
Page 68
K5 System Technical Guide
5) Now Set the new room address for the monitor navigation button, and press menu button to
save the setting
Code Number: [
1
002]
0010: delete remotes
0011: add remote
0020: set as door bell
0021: not door bell
0022: have door station
0023: no door station
0030: out-delay set
0031: in-delay set
0080: room id set
0090: test armed
0093: direct call gl vd on
0094: direct call gl vd off
8008: MM/DD/YYYY
8009: DD/MM/YYYY
8012: 12 hour format
8013: 24 hour format
2412: restore to default
4.3.3§Address§Setting§with§door§station
Monitor address also can be set via door station. The steps as follows, take IP-MR18 as an example:
Step1: Entry Monitor Program Page
[----]
Please Input Password
1
2
3
6
5
4
7
8
9
#
0
*
RF CARD
[--------]
Please Input Password
1
2
3
6
5
4
7
8
9
#
0
*
RF CARD
=== Monitor Program ===
Old M. code [ - - - - ]
New M. code [ - - - - ]
>Press Call Button of the
monitor
>Input new Code
>Press # to Program
[ Press Call Button ]
Press # key on
door station
Then input 8003
Input the password:
66666666(Default)
Then entry Monitor
Program page
Chapter 4 K5 System Settings