V-Tech CAT5 System Technical Guide - Manual (Page 54)

Page 54 K5 System Technical Guide
1 . I D C o d e [ 0 - 1 1 ]
2 . U n l o c k T i m i n g [ 0 1 ]
3 . U n l o c k O u t p u t [ 0 ]
4 . C a r d M e m o r y [ 0 ]
5 . D o o r p l a t e M o d e [ 0 ]
6 . A u d i o O p t i o n s . . .
7 . P a r a m e t e r s . . .
9 . D e f a u l t . . .
Press1~9
to select
*Back
Installer
Setup
8 . I n s t a l l e r C o d e . . .
2 . S e t u p
4 . O n l i n e M o n i t o r s
5 . O n l i n e D e v i c e s
*Back
Tools 1 . I n s t a l l e r S e t u p
3 . C a r d M e m o r y
1 . A d d C a r d . . .
2 . D e l e t e B y C a r d
3 . D e l e t e B y M . c o d e
4 . C a r d I n f o r m a t i o n
5 . F o r m a t
Press No.
to select
*Back
Card
Memory
About access Memory
• The access cards can be saved in the door station ,for this , the Card memory in Installer setup,
Must be set to 0(It is 0 by default)
• The access cards also can be saved in the C5-IPC connected with the door station. For this, the
Card memory in Installer setup should be set to 1.
About cards
• User Cards are associated with Room Code; an authorized User Card can open the door at any
time.
• Manage Card is restricted to pre-defined access rule, and hold by visitor or service person.
• Please note, Manage Cards can only be saved in C5-IPC and authorized by means of IP-Access
software.
• To authorize cards, enter Card Management first (refer Chapter 6.1 to), then select the item.
• Please note that the following operations are irreversible.
Chapter 4 K5 System Settings